Unfortunately, if a solar hot water Perth system is not properly constructed, you may not notice a problem for a long time. The biggest disappointment may be discovering that, despite your best efforts to lower energy bills and save money, nothing was saved due to improper installation. Since it was installed many years ago, one hot water system had never produced a drop of free hot water – find more info.
Here are some helpful hints:
- Solar Hot Water System Oversizing:- If you have a small family, don’t buy a large solar water system unless you need a lot of hot water on a regular basis. The greater government rebates available with larger solar water systems can be enticing since you might think you’ll be able to store more hot water as a backup in case the weather turns bad and the solar collectors can’t produce hot water.
- It’s Crucial to Put Solar Collectors in the Right Place:- It’s critical to get the solar collectors positioned and pitched precisely so that they can reach their full efficiency potential. Before you begin installing the solar collectors, consult with your installer and make sure you and the installer agree on where the solar collectors will be placed.
If the system is built in the summer, keep in mind that when the sun is lower in the sky, shadows from neighboring buildings or trees will be longer, casting a shadow on the collectors and reducing their effectiveness.
- The Electronic Controller’s Positioning:- A’split’s solar hot water system is one in which the collectors are located on the roof and the storage cylinder is located on the ground. This type of system typically comes with an electrical controller that controls a circulating pump to transport water from the storage cylinder to the solar collectors and back to the cylinder once the water has been heated by the collectors. The electronic controller is commonly housed in a plastic box that is mounted on the wall next to the solar hot water system or on the storage cylinder itself. Make sure the controller is kept dry and out of direct sunlight. Long-term exposure to direct sunlight on the controller will render the plastic brittle and susceptible to cracking, eventually affecting the controller’s circuits. Replacement costs range from $150 to $250 AUD.
- Putting The Circulating Pump In The Right Place:- The circulating pump is usually housed in plastic housing. To avoid the plastic shell becoming brittle, the circulating pump should be kept out of direct sunlight.
If the pump is situated outside where it is likely to be exposed to rain, special attention must be paid to ensuring that the circulating pump’s electronics remain dry and that there is adequate ventilation surrounding the pump. Rain will be kept from reaching the housing where the pump’s electronics are stored in some cases by positioning the pump on its side. In most cases, the manufacturer will include a handbook detailing the many places in which the pump can be mounted, as well as those that are not advised. Installing the pump upside down is not a good idea since the pump motor may overheat.
Conclusion:- It is well worth your time to speak with specialists in order to get the ideal system and the work done correctly. It’s a significant investment. You don’t want to have to replace a solar hot water system in less than 5 years. Make every effort to reduce wear on solar hot water system components and ensure that it is operating at peak efficiency.